We are doing a fund raiser comp to help a 5 year old girl who has to undergo cancer treatments. she had a football size tumor attached to her kidney which was an emergency surgery! she will be spending a lot of time at primary children's with cancer treatments. The money raised from this comp will go to the family to help with medical bills. There will be raffle prizes and a trophies for class 1,2,3! please come out have some fun and donate to a local Utah family!
15 dollar entry fee per class
Competition Rules
Scoring
Low score wins.
Hitting a gate is a 10 point penalty the entire gate is dead when one cone is hit.
Reverse is a 1 point penalty.
Progress through a bonus gate is -10 points. Hitting a bonus gate is a 10 point penalty. These points can cancel each other out.
Bonus gates can be run at any time before gate 10 is crossed.
A rollover is 5 points to upright the truck. Reposition is 10 points to move the truck back on course. You can place truck at previous cleared gate!
Use of a winch is 5 points.
Repair while on course is 10 points (between courses no penalty)
Course runs will be timed for a tie breaker.
Time limit for each course is 6 minutes.
Course flow
Gates must be completed in order and traveled through in the specified direction. Numbered and Arrow directional cones will be on each gate to help.
If you can not complete a gate, you must K*ll the gate to move on, which will add to your score.
Backing through a gate in the specified gate direction is allowed.
Gates are directional, you can not back through a gate from the wrong side then travel through forward to clean the gate, It must only be entered from the specified direction. You must attempt to make it to a gate to K*ll it, if you can not reach the gate, the judge can mark it as a dead gate and you can move on to the next gate after an attempt to reach it.
Boundary lines are equivalent to hitting a cone, same as a cone if it is touched at all it is a 10 point penalty. If you roll across the line it is a 10 point penalty. Stay within the boundary line.
You do not have to finish a bonus you have attempted, you are free to move on at any point.
Course run will be timed. Overall time on all courses is the tie breaker, if time is the same course 1 score is tie breaker then 2 and so on.
If a truck moves anything to disrupt a cone, it is not counted as a gate penalty.
Vehicle Classes
Class will be designated before starting courses.
Gate width minimum 13”
Class 1 cheater
4.19 max tire size
chassis rails with with chassis mounted motor and transmission
chassis must be the length of the wheel base
bumpers front and rear must be wider than the chassis and stick out past the body, must be rigid mounted plastic or metal bumpers no rollers or rubber bumpers
Bodies must be the length of the wheelbase and NO cab only body's/with or without flat bed
no dig or 4ws
must have a flat skid!
Class 2
4.75” max tire height
Chassis rails with chassis mounted motor and transmission
No use of Dig allowed
No use of rear steer allowed.
Capra is allowed in Comp car class as long as no dig or 4WS is used. Frame must be the length of the wheelbase
No Pin Tires In class 2
Class 3
5.75" max tire height
Chassis rails with chassis mounted motor and transmission
Rear Steer and dig allowed
Frame can be 2 inches smaller than length of wheelbase!
No pin tires in class 3
Drivers meeting will be at 9am course will start at 9:30
Also check out other Workshops in Elberta, Contests in Elberta, Sports events in Elberta.
|
